7-28
■■
Length Measure - measuring length between two selected points
Use the manual key to reach the
standard point.
Place the cursor at “1. LENGTH
MEASURE”in the sub menu.
Press
Use the frame move key to move to
the desired point.
Press when you want to stop
1. LENGTH MEASURE
2. DESIGN TRACE
3. OPTIMIZE TRACE
X: 0,Y: 0
[ Machine data screen]
X: -108,Y: 85
Lengths in the X and Y directions up to the cursor are
indicated on the screen (in mm) as you move the frame
[ Menu screen ]
LENGTH MEASURE
To Next Page
Loading...
