REMOTE CONTROL RE-PROGRAM INSTRUCTION
If your remote will not work, first check to see that it is transmitting. Do this by depressing any
of the three buttons and watching to see that the red LED light is working. If so, then the next
step is to re-program the receiver..
1. Push and release ‘Up’ button once on transmitter to ‘wake up’ receiver from
sleep mode
2. Push programming button on right side of RC Box
3. Push ‘Up’ on a transmitter 3 times.
Repeat for each transmitter
(Note: Programming of receiver can be cleared by holding program button for
45 seconds).
FORM NO.
PAGE 11 OF 15
690249 OPERATION
To Next Page
Loading...
