Sunstream SWIFTSHIELD A Series - Bow Sprit Installation

FORM NO. 660769 REV. C PAGE 33
2-Q
Bow Sprit Installation
Steps:
1. With boat raised, in the standard position on SunLift™.
2. Insert spreader pipe through hole in end of bow sprit extension tube, hold in place with
cotter pins.
3. Apply anti-seize to all bolt threads before installing nuts.
4. Position bow sprit in the center of SunLift™ front cross beam. Clamp in place with nuts
and bolts.
5. Insert bow sprit extension tube into welded tube.
6. Extend bow sprit to be between 0” - 12” in front of bow, directly below roller.
7. Lock in place with 3/8-16 x 3.5” bolt and nut.
8. Properly torque all nuts on bow sprit.
Spreader Pipe
Cross Beam
5.
Bolt SS,
3/8-16 x 3”
2 Places
Nut SS, Nylok
3/8-16
2 Places
Bow Sprit
Extension Tube
12”-14”
7.
* Hydraulic hoses not shown.
Welded Tube