FORM NO. 660769 REV. C PAGE 40
1. With roller in aft position
2. Locate 3/4” nut on port end of Roller assembly.
3. Refer to decal on roller for proper torque value. Two torque values exist depending on
which spring is used in roller.
4. Tension roller by applying torque specified on decal; approximately 55 revolutions.
5. The roller contains a clutch mechanism designed to prevent over-torquing the spring.
5. Locate the bungee cord and carabineer, at the aft corners of the cover.
(May be inside the sleeve.)
6. Wrap the bungee cord under and around the roller.
7. Wrap once or twice inboard, towards the center of the boat. Attach bungee cord to
D ring.
3-G
Tensioning the Roller
2.
5.
6.
Torque Table
Roller
Width
Approximate
Revolutions
Max Torque
ft-lbs
126” 55 29
138” 55 37
To Next Page