FORM NO. 660769 REV. C PAGE 41
Steps:
1. With cover fully installed and boat covered. Inspect bottom edge of cover.
2. Bottom edge of cover should be horizontal, parallel with the water.
3. Adjustment is an incremental process. Start by removing the smallest puck, and con-
tinue 1/4” increments until proper arm height is achieved.
a. If the arm needs to go lower, start by removing the 1/4” “puck”.
b. If the arm still needs to go lower, remove the 1/2” puck and put the 1/4” puck back in.
c. If the arm still needs to go lower, remove the 1/2” & 1/4” pucks. = 3/4” removed.
d. If the arm still needs to go lower, put both 1/4” and 1/2” pucks back in, and remove a
1” puck, etc.
3-H
Adjusting Cylinder Stroke
To Next Page