To Next PageTo Next PageHow to fix marginal outlet flow in SunSun Water Filtration Systems?
Marginal outlet flow in SunSun Water Filtration Systems can often be attributed to two main causes. The filter foam may be very dirty, requiring a thorough cleaning. Also, check that the gap between the water level and the top of the aquarium does not exceed 4 cm (1.55 in). Add water if needed to maintain the correct water level.
What to do if my SunSun Water Filtration System pump does not operate?
If your SunSun Water Filtration System pump isn't working, there could be a few reasons. First, ensure the power is switched on. Second, the impeller might be blocked, so try cleaning it. Lastly, the pump may be running dry; in that case, fill the canister with water.
Why is my SunSun Water Filtration System pump too noisy?
A noisy SunSun Water Filtration System pump can stem from a couple of issues. It might be running dry, so ensure you fill the canister with water. Alternatively, the impeller could be blocked, or the pump shaft might be worn out. Try cleaning the impeller, and if the noise persists, consider replacing the pump shaft.
Important safety notes and operational advice for the filter installation process.
Important safety notes and operational advice for the filter installation process.
General| Brand | SunSun |
|---|---|
| Model | HBL-801 |
| Category | Water Filtration Systems |
| Language | English |
