Need help?Do you have a question about the Suntex SC-110 and is the answer not in the manual?
General| Model | SC-110 |
|---|---|
| Category | Measuring Instruments |
| Manufacturer | Suntex |
| Display | LCD |
| Operating Temperature | 0°C to 40°C |
Outlines the accuracy of conductivity, resistivity, salt, and TDS measurements.
Explains the automatic temperature recognition and compensation.
Describes the methods for manual calibration.
Describes the function and operation of each key on the keypad.
Instructions on how to start and perform measurements.
Explains temperature measurement and compensation methods.
Configuration of various operational parameters.
Instructions to delete all data stored in the instrument's memory.
Procedure to perform a system reset to factory defaults.
Procedure for calibrating the electrode coefficient.
Steps for performing a single-point calibration.
Procedure for multi-point calibration using standard solutions.
Troubleshooting common error messages during calibration.
Step-by-step guide for configuring RS232 communication with Hyper Terminal.
Identifies failure phenomena, possible causes, and dispositions.
To Next Page