4
3. Operation
3.1 Measurement:
Push key to start up the instrument. It will automatically enter the measurement mode
of final operation and begin to measure.
3.2 Measurement function and file bit shift:
1. Push key to shift among Cond., Salt, and TDS in Cond. Mode. This function is
unavailable in Res. mode.
2. Push + keys to shift among the five manual shifts and the auto shift. After
entering auto mode, AUTO characters will disappear after 3 seconds.
Remark: Before measuring salt and TDS, please finish the calibration according to the
conductivity calibration steps, and then set the factor value according to the standard
solution of salt and TDS.
Push to shift
Salt unit
Push to shift
TDS unit
Push to adjust
the salt value. Note:
Factor range is 0.4~1.5
Push to adjust
Total Dissolved
Solids. Note: Factor
ran
To Next Page
Loading...