SUPAIR STRIKE 2 - Reserve parachute;risers

Harness User’s manual | STRIKE 2
SUPAIR | STRIKE 2 | page 17
1 2 4
5
3
INSTALLING THE RESERVE PARACHUTE
Reserve parachute/risers
- Open the 7mm square
Maillon Rapide®
- Push the maillon through
the risers loops
- Push the maillon through
the plastic ring
- Twist
- Give a second twist to
the plastic ring.
- Push the buckle through
the maillon.
- Push the two riser ends
through the toric ring loop.
- Push the maillon through
the riser loop
- Tidy up the assembly.
- Be certain for the riser end loops to be securely
fastened.
- Close the Maillon Rapide® tightly by hand.
- Tighten using pliers and making a ¼ turn.
One (1) square 7mm Maillon Rapide® will be needed + two (2) flexible toric rings.