EasyManua.ls Logo

SupaScoota SPRINT - Battery Care & Maintenance; SLA Battery Wiring Diagram

SupaScoota SPRINT
21 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BATTERY CARE & MAINTENANCE
Important notes to help prolong the life of the battery:
Before the first use of your battery, put it on charge for 24
hours.
Do not place the battery on a concrete floor for charging, have
the battery raised off the floor on wooden blocks or place the
battery on a shelf. (when moving the batteries out of scooter
for recharging)
To fully charge the battery, choose a place where ambient
temperature is above 10 degrees Celsius.
Always recharge your battery as soon as possible after use.
When yellow light is “On” you should recharge your battery as
soon as possible.
Never use the battery when the red light is “On”. You will
discharge the battery below its designated voltage and
damage it.
Do not drop the battery.
STORAGE:
If you know that you will not be using your battery in the near
future, disconnect the battery from the charger and store it in a
suitable dry place.
Recharge your battery before you use it or every 3 months (No
more than 3 months) if it is not used in that period.
Always contact our service agent before you replace the battery
or the charger. Using an incompatible battery or charger may
damage the scooter and void your warranty.
NOTE: The battery gauge on the scooter does not give accurate
readings when using a lithium battery, unless reselect to meet
the right voltage. (P.25)
- 35 -
SLA BATTERY WIRING DIAGRAM
SLA battery 15ah
2 x 12V 15ah
Lithium battery module
25.6V 15ah & 25.6V 12ah
This lithium battery module has individual user’s manual.
Read before use.
- 36 -

Related product manuals