EasyManuals Logo

Supco IAQ50 User Manual

Supco IAQ50
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
4
%%
OO
CO2
%%
OO
CO2
Fig.3
Fig.4
TAKING MEASUREMENT
Press to switch temperatures
display. The lower left display will cycle
from air temperature, dew point temp.
(Fig.3), and wet bulb temp.(Fig.4).
The meter starts taking measurement
after power on and updates readings
every second. In the condition of opera
-ting environment change (ex. from high
to low temp.), it takes 30 sec to respond
for CO sensor and 30 minutes for RH.
2
NOTE: Do not hold the meter close to
faces in case that exhalation affects
CO levels.
2
AIR, DP, WBT
DP/WB
PPM
PPM
Under normal mode, press to see
the minimum, maximum, and weighted
average readings. Each press of ,
it displays MIN, MAX, STEL, TWA in
sequence and returns to normal mode.
In MIN and MAX modes, it shows the
minimum and maximum readings of
CO on main display and of AIR or DP
2
or WB temperature and humidity on
the lower displays. (Fig.5)
Fig.5
M /
X
N
AVG
M /
X
N
AVG
%%
OO
CO2
PPM
MAX,MIN, STEL,TWA

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Supco IAQ50 and is the answer not in the manual?

Supco IAQ50 Specifications

General IconGeneral
BrandSupco
ModelIAQ50
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals