No power, “POWER” not on
Error Causes Solutions
1. Battery is poorly connected
1. Connect the power cable appropriately
2. Kill switch is not turned on
2. Turn on the kill switch
Power on, turning accelerator,
motor not run
Speed is too slow or mileage
is too short
Battery cannot be charged
Low battery power
Side stand is on
At parking mode
Brake lever does not reach the
right position
Accelerator error
The controller plug is loose
Controller error
Low battery power
Flat Tyre
Heavily overloaded
Brake pads need to be replaced
Battery aging or normal scrap
1.
2.
3.
4.
5.
Poor contact of charger plug
Used wrong charger
Battery aging or normal scrap
1.
2.
3.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
6.
7.
Charge the battery
Kick the side stand out
Press parking button
Place the brake lever at the right position
Change accelerator
Re-plug controller
Change controller
Charge the battery
Pump up the tyre, check tyre pressure before riding.
Foster a good habit, keep an appropriate load
Change the brake pads and check the brake system
before riding
Change battery
1.
2.
3.
Check whether the battery plug is at right position or not
Use SUPER SOCO charger
Change battery
a.FAQ & TROUBLE SHOOTING
FAQ & TROUBLE SHOOTING
25