Super Systems 31095 - Operation: Setpoint Management; Setpoint Menu Parameters

36
4 - Operation
4.4.1 PARAMETERIZATION - SETPOINT MENU
Menu
S.P.
L=r
éLoc
SL. u
SL. d
éOFF
éOFF
S.P. H
éH.réange
S.P. L
éL.réange
Bias
é 0
rtio
é 1:00
S.P. 2
S.P. 3
é 0
é 0
S.P. 1
é 0
S.Sel
énone
LOCAL ONLY
INDEX
#Loc
LOCAL/REMOTE,
REMOTE OR PROGRAMMED
INDEX
#L=r #reM #Prog
LOCAL WITH TRIM OR
REMOTE WITH TRIM
INDEX
#Loc.t #reM.t
Stored Setpoint
selection
none/ S.LOC/
S.S.P1 / S.S.P2/
S.S.P3
1st stored
Setpoint
full scale
2nd stored
Setpoint
full scale
3th stored
Setpoint
full scale
Ratio Setpoint
-9.99…99.99
Remote
Setpoint bias
full scale
Setpoint selection
local/remote
Loc / reM
Setpoint
low limit
full scale
Setpoint
high limit
full scale
Slope up
0ff/1…9999 digit/
[1]
Slop down
0ff/1…9999
digit/..
0ff/1…9999
digit/ [1]
Depending on the configuration index shown on page 27,
the following parameters may or may not be present.
[1] The units of the slope parameters are Digit/s, digit/min digit/h
Setpoint menu
X5-SSI-uk 18-03-2009 17:53 Pagina 36