Super Systems 31095 - Page 58

58
6 - Commands
COMMANDS TO THE CONTROLLER AND OPERATING PHASES
6 COMMANDS
The commands can be
entered in 3 ways:
6.1 KEYPAD
see page 55
• Setpoint modification
• Manual mode
• Local/remote selection
• Stored Setpoint display
• Tune Run / Stop
• Program start/stop
(see page 66)
6.2 DIGITAL INPUTS
see page 58
6.3 SERIAL
COMMUNICATIONS
see the manual on this topic
X5-SSI-uk 18-03-2009 17:54 Pagina 58