1. Handling in general
2. Check before operation
WARNING
WARNING
CAUTION
Do not operate until the contents of the operation manual,
and caution tag/plate are thoroughly read and understood.
Do not operate without a legal qualification.
Be sure to clear of the area of the operation for lifting or
turning a load against possible drop off or fall over.
Do not use for other than intended purpose.
●
●
●
●
●
●
●
●
●
●
Make sure to execute an inspection periodically and before
each operation.
●
●
●
Sling to be used for the clamp shall be an appropriate one for
lifting operation.
Do not use clamp for the load under the following conditions.
(Load to be lifted is more than 150℃, or in an atmosphere or
solution of acid or alkaline chemicals less than minus 20℃)
Do not use clamp unsuitable for the operation method.
Do not use clamp of an abnormal condition; deformed,
cracked, worn, malfunctioning, etc.
If the load is under the following conditions, do not use clamp.
(A material of fragile, high-hardness, low-hardness or
extremely low-hardness, or a member with the gripping part
tapered down more than 8°)
Check the type, rated capacity, clamp range, and “periodic
inspection completed” label displayed on clamp body.
The load to be lifted shall be within an allowable range of
rated capacity of clamp.
Thickness of load shall be within designated clamping range.
Prohibited
Prohibited
Prohibited
Instructed
Instructed
Instructed
3
To Next Page
Loading...