Need help?Do you have a question about the Super SJC and is the answer not in the manual?
Check clamp suitability, condition, capacity, range, and inspect labels before use.
Avoid single-point lifting, overlapping loads, strong winds, or hydraulic shovel use; ensure balanced systems.
Never exceed rated capacity, avoid impacts, do not allow personnel on load, and lift only free objects.
Do not alter clamps, use non-genuine parts, or attempt repairs; qualified personnel must perform repairs.
Choose the correct model, verify load weight, capacity, and clamp range; never exceed limits.
Check clamp condition, cleanliness, full load insertion, cam bite, and safety lock engagement.
Ensure load balance and use equal ropes for 2-point lifting, keeping angles within 60°.
Avoid lifting multiple plates, check center of gravity, clear personnel, and do not ride on loads.
Do not alter clamps; avoid welding loads; perform daily maintenance and lubrication.
Explains screw operation, cam retraction, and achieving firm contact for secure gripping.
Insert load fully into jaw opening and tighten screw firmly for square contact with cam teeth.
When lifting at two points, maintain the lifting angle within 60 degrees for safety.
For complex objects, lift at 3 points, balance workpieces, and keep angles within 60°.
Adhere to capacity, range, material type; avoid hard loads, tapering, shocks, or multiple plates.
Check for cracks, measure jaw opening, and inspect shackle/screw hole deformation.
General| Brand | Super |
|---|---|
| Model | SJC |
| Category | Industrial Equipment |
| Language | English |
To Next Page