4
3. Lifting operation
4. Operation of a crane
WARNING
WARNING
CAUTION
Never lift a load exceeding the rated capacity.
Do not operate a crane in such a way as to give an impact to
the load or the clamp.
Do not allow a person to stand on the load or to carry him.
Do not lift a load which is not free from any other objects.
Do not release the lock of clamp while lifting load.
Avoid unintended contact by load to an adjacent member or to
the clamp, which has been removed from the load.
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
Do not use clamp, lifting at one point.
(excluding special or custom ordered products)
Do not use the clamp in the following ways of lifting: lifting of
two or more individual objects at one time. (overlapped loads,
padded load etc. , or side gripping)
Do not use the clamp for pulling out steel plate sheet from the
steel sheet pile or for vertical lifting of the sheet.
Do not use the clamp when strong wind may threaten to cause
any danger.
Do not use the clamp for a hydraulic shovel.
If oil, paint, scale, rust, etc. are on the gripping pad, do not use
the clamp.
Do not drop clamp or drag on the ground.
Install two or more clamps in a balanced way to keep the
balance of load.
The lifting angle of the clamps and the dividing angle should be
kept within the allowable angles according to types.
Load should be inserted to the innermost end of the jaw open-
ing.
When you use the clamp with a lock mechanism, never fail to
have the lock engaged.
Prohibited
Prohibited
Prohibited
Two point lift
Instructed
To Next Page
Loading...