Super SJC - Lifting Configurations and Techniques; Two-Point Lifting Setup; Multi-Point Lifting Setup

14
2. METHOD OF USE
(1) When lifting at 2 points, keep the lifting angle within 60°.
(Always lift work pieces at 2 or more points for safety).
(2) Always lift at 3 points with complicated shaped objects, and balance the work pieces
at the proper clamping position and with the proper length of wire rope.
Keep the lifting angle within 60° between ropes.
(When lifting steel plates horizontally, always lift at 4 points.)
(3)The clamps can also be used shaped steels temporarily for turning over.