16
Wedge shapes over 8°※
Round bars
Curve shapes with
radius under 300mm
Objects with uneven
surface (no flat surfaces
for clamping)
Do not lift when clamped the tapered
side even if the wedge shapes under 8°
※
○ DISASSEMBLING
1
○ ASSEMBLING
2
(1) Turn Screw counterclockwise and remove
it from the Body.
(3) Remove two stopper pins from the cam holder and
detach the circular cam and the retaining ring.(Fig.2)
(2) As show in the drawing on the right, tilt the
circular cam and remove the retaining ring
with snap ring pliers. Next, remove cam
holder, steel ball and spring from the body.
(Fig.1)
Connect the retaining ring temporarily on the stem
of the circular cam.
Insert the circular cam into the cam holder from the
sphere-shaped section and fix them with two stopper
pins.
Insert the spring and next steel ball into the bottom
hole of the cam holder.
I
nsert the cam holder assembly of ② into the hole of
the body and then make sure to set the steel ball of
③to the bottom hole of the cam holder.
Fix the retaining ring of ① to the groove of the body
with snap ring pliers.
Replace and tighten the screw.
①
②
③
④
⑤
⑥
(Fig.1)
(Fig.2)
To Next Page
Loading...