Super SK - 4 Troubleshooting

9
Failure scenarios Cause Of Failure Approach
Insufcient
Filtrations
• Filter Bag Is Not Installed
Properly.
• Filter Bag Or Cartridge Is Clogged.
• Make Sure Parts Are Installed
Properly.
• Clean The Debris Or Residues
That Might Cause The Clog.
No Flow From
Outlet,High
Pressure
• Clogged Pipline / Filter Or Valve Is
Closed
• Clean The Pipline/Filter
• Open The Valve
Cleaned
Filter With High
Pressure
•
Cartridges / Filter Bag Are Seriously
Blocked.It Has Become Ineffective
• Cartridge / Filter Must Be Replace.
No Flow From
Outlet,No
Pressure
• Jammed Pump Impeller
• Pump Failure
• Clogged Inlet
• Closed Inlet Valve
• Clean/Free The Impeller
• Repair or New Pump
• Check The Inlet
• Open Inlet Valve
Bubbles From
Outlet
• Air Been Inhaled Into The Pump Check For Leaking
• Loose Pipeline,Or In-Tank Air Line
Is Too Close To The Inlet
• Move The In-Tank Air Line
• Secure Or Reseal Inlet PipeLine
Pump Leaking
• Damaged Seal
• Damaged Pump Parts
• Replace Damaged Part
Burnt Motor
• Jammed Impeller • Clean Impeller and Add Strainer
• Single-Phase Operation
• Install Overload Shut-Off Switch
• Check Power Switch
Pressure Gauge
Does Not Move
• Bad Pressure Gauge Seat Seal
• Damagd Pressure Gauge
• Reseal And Reinstall Pressure
Gauge
• New Pressure Gauge
Inaccurate
Pressure Gauge
• Gauge Is Leaking Fluid
• Damaged Diaphragm
• Defected Pressure Gauge
• Rell Guage With Water
• New Diaphragm
• New Pressure Gauge
Filter Top Cover
Is Leaking
•Debries Build Up On Cover
Packing
• Damaged Cover or Cover O-Ring
•Clean The O-Ring & Cover
Packing
• New Cover/ O-Ring
Low Flow And
No Sign Of Filter
Clogging
• Pump Is Spinning At The Wrong
Direction.
• Correct The Spinning Direction
• Clogged/Stucked Impeller
• Clogged/Blocked Foot Valve/
Strainer
• Remove/Clean The Impeller
• Remove/Clean Foot Valve/
Strainer
4.Troubleshooting