Super SK - Filter Operation Instructions

4
2. Instructions
(Please Read The Instructions Carefully)
1. Make Sure The Pipeline Are Fully Secure And Sealed.
2. Fill The Pump With Water (Pg. 18 Figure 1), Open Air Release Valve (19) &
Water Injection Valve(10),Fill Tube (8) With Water,Open Tube Valve (10) Let
Water Fill Up The Pump, Or Open Cover (7), Fill The Filter Barrel With Water.
Make Sure The Inlet Is Filled With Water To Prevent Pump From
Dry-Running.
3. Check The Voltage and Motor Junction Box For Any Miswire Before Starting
The Motor.
4. Before Starting The Motor Close Tube Valve (10) Then Let Air Water
Escape from Air Release Valve(19),To Tube (8)
5. Before Turning The Power On Check the In/Outlet Are Connect Correctly.
Example:Sign of Damage on Pipeline,In/Outlet Valve Are Open & ETC.
6. After Above Procedure.Turn On The Pump,Make Sure The Pump Is Turning
At the Right Direction.If Not, There Won't Be Water Coming Out From The
Outlet.Simply Switch It the Direction From Motor Junction Box.
7. Make Sure Tube Valve(10) Is Close,And Tube (8) is Empty.Prevent Air From
Entering The Pump And Cause Cavitation or Dry-Running.
8. Check The Pressure Gauge (15) Before Operating The Filter And Make Sure
There Is Oil Inside The Gauge.
9. While Working In A Hostile Enviroment:
Wear Protective Clothing (Gloves
Boots & Etc.)
10. Check All The Safty/Protection Switch:For Example: Holding Tank Liquid
Level, Power Protection Switch And Etc.