12
English
PRESA D'ARIA ESTERNA CON
GRIGLIA NON RICHIUDIBILE
d
DT2030341-00
Fig. 23
1
.11 Using external flue ducts
You can use external flue ducts only when they correspond to the follo-
w
ing requirements:
- Use only insulated pipes (double-lined) in stainless steel attached to
the outside wall (Fig 23).
-
At the base of the duct there must be an inspection hatch to permit
periodic checks and maintenance.
-
The installation must be equipped with an windproof chimney and
respect the safety distance from the high point of the roof as outlined
in the chapter entitled “GENERAL RULES”, under “Chimney top”.
Ensure that all installation work is carried out to professional
standards.
1.12 Prevention of domestic fires
The product must be installed and used in compliance with the manu-
facturer’s instructions and European and national standards as well as
local regulations.
When a flue pipe passes through a wall or a ceiling, special
installation methods must be applied (protection, thermal
insulation, distances from heat-sensitive materials, etc.) See
the paragraph “Connection to the flueway”.
- It is also recommended that all elements made of combustible or
inflammable material, such as beams, wooden furniture, curtaining,
flammable liquids, etc. be kept outside the heat radiation range of the
stove and in any case at a distance of at least 1m from the heating
block.
- For other information, see the paragraph “
Safety distances” and
“
Connection to the flueway”.
- The flue pipe, chimney stack, chimney and fresh air intake must
always be free of obstructions, clean and checked periodically, that is,
a
t least twice during the seasonal period from the lighting of the stove
and during its use. When the stove has not been used for some time
it is advisable to carr
y out the checks mentioned above.
F
or further
information, consult a chimneysweep.
-
Only use recommended fuels (See paragraph “
Fuels”).
Fresh air intake with
non-closable grille
To Next Page