EasyManua.ls Logo

Superior MIRELLA - User Manual

Superior MIRELLA
40 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
INSTRUCTIONS FOR
INSTALLATION, USE AND
MAINTENANCE
Pellet Stove MIRELLA
SUPERIOR
®
The instruction manual is an integral part of the product.

Table of Contents

Questions and Answers

  • D
    David WilliamsAug 10, 2025
    What to do if my Superior MIRELLA Pellet stove control panel display is not lit?
    • K
      Kathryn BurnsAug 10, 2025
      If the control panel display is not lit, there might be a few reasons. First, check that the power lead is properly plugged into both the wall and the stove. If the issue persists, replace the power lead with an original spare. Also, inspect the fuses in the plug and on the electronic board, and replace them if needed. If these steps don't resolve the problem, consider replacing the control panel or the flat cable, always using original spares. If the problem still continues, call an electrician.
  • L
    Lisa BrownAug 15, 2025
    What to do if my Superior Pellet stove failed ignition with "NO ACC"?
    • M
      Melissa SmithAug 15, 2025
      If your Superior Pellet stove displays "NO ACC" indicating failed ignition, start by checking if the fuel tank is empty and refuel if necessary. If that's not the issue, try emptying the burner and restarting the stove. If the problem continues, consider replacing the pilot light or the electronic board, always using original spares.
  • L
    Lisa GatesAug 20, 2025
    Why does my Superior MIRELLA show "AL 1" "NO DEPR" external pressure reader warning?
    • L
      Laura CaseyAug 20, 2025
      The "AL 1" "NO DEPR" warning on your Superior Pellet stove could be due to a blocked flue, so you should check and clean it. If the problem continues, consider replacing the motor and check all washers and linings, ensuring you use only original spares.
  • P
    patellisaAug 25, 2025
    What causes the exhaust outlet temperature warning "MASS tEMP" in my Superior MIRELLA Pellet stove?
    • R
      rita53Aug 26, 2025
      The "MASS tEMP" warning on your Superior Pellet stove can be triggered by a blocked flue, so start by cleaning it. If the issue persists, you might need to replace the sensor. Also, check the positioning and connection of the sensor, referring to the electrical diagram.
  • H
    hintonjamesAug 30, 2025
    What does it mean if my Superior MIRELLA smoke sensor is disconnected and shows "NO CONN"?
    • D
      Dwayne PerezAug 30, 2025
      If your Superior Pellet stove displays "NO CONN" for the smoke sensor, it indicates a disconnection. Check the positioning and connection of the sensor at the 2-pin terminal, referring to the electrical diagram.
  • K
    Kayla HodgesSep 3, 2025
    Why does my Superior MIRELLA Pellet stove run for only 9-10 minutes then goes out?
    • N
      nbeckSep 4, 2025
      If your Superior Pellet stove runs for only 9-10 minutes before shutting down, it could be because the heat sensor is blocked. Retry, and if the problem persists, contact an authorized technician. It might also be necessary to replace the electronic board.

Superior MIRELLA Specifications

General IconGeneral
BrandSuperior
ModelMIRELLA
CategoryPellet stove
LanguageEnglish