2
English
Dear client,
We thank you for choosing one of our products, the result of technological expertise and continued research in pursuit of a superior prod-
uct in terms of safety, reliability and features.
I
n this manual you will find all the information and useful advice necessary to get the most out of your appliance in total safety.
D
T2010001-00
IMPORTANT INFORMATION
D
T2010208-02
REFERENCE STANDARDS
DT2010209-00
The assembly of the cover should be undertaken by two people (follow the assembly instructions in the attached booklet).
Plans and diagrams are supplied as examples at the manufacturer’s discretion; in the pursuit of a policy of continuous development and innova-
tion the manufacturer may, without prior warning, make any modifications deemed appropriate.
This document is the property of Gruppo Piazzetta S.p.A.; it may not be divulged in part or in whole to third parties without written permission from
Gruppo Piazzetta S.p.A. Gruppo Piazzetta S.p.A. reserves all its statutory rights.
•
This manual has been prepared by the manufacturer and constitutes an integral part
of the product, and must accompany it throughout its life. In the event of sale or relo-
cation of the product make sure this booklet accompanies it, since the information
contained in it is addressed to the purchaser and to anyone involved in the installa-
tion, use and maintenance of the product.
• Read the instructions and the technical information contained in this manual care-
fully, before proceeding with installation, use or any repairs.
• The observance of the instructions and technical information in this manual guaran-
tees the safety of the user and the product, a more efficient operation and an
increased lifespan.
• The product’s installation and use should conform to the manufacturer’s instructions
and to local bylaws.
• However, when carrying out any operation we recommend that you follow carefully
the instructions contained in this manual, and that you keep it at your disposal.
• Installation, electrical connection, checks, maintenance and repairs are operations
which must be carried out exclusively by qualified and authorised personal with spe-
cialised knowledge of the product.
• Before installing the product read all instruction booklets relating to installation of the
cladding, the ventilation kit and any other accessories.
• Be very careful when moving any ceramic components.
• Check that the floor where the product is to be installed is exactly level.
• To help correct potential unevenness and irregularities a sheet of adhesive fibreglass
accompanies the product.
• Do not block the electrical socket; it should be close to the unit but accessible.
•
Connect the pellet stove to the electricity supply only after it has been connected by
an expert to the flue system.
• The plug at the end of the power supply cable must be easily accessible after instal-
lation.
• Use only regulation wood pellets (refer to section entitled “Technical charateristics
and specifica
tions”
).
•
Never use liquid fuels to light the stove or to relight the embers.
• Ensure that the area where the stove is installed is properly ventilated while the stove
is lit.
• In the event of technical faults the fuel supply will be interrupted. Restart the stove
only after having eliminated the cause of the fault.
• The wall where the product is to be placed should not be of wood or any other flam-
mable material; furthermore it is important to maintain safety distances (refer to sec-
tion entitled ‘Prevention of domestic fires’ contained in the stove’s manual for use
and maintenance).
• Do not remove the protective grille from the fuel storage tank.
• Any build-up of unused pellets in the burner left over from repeated failed ignitions
must be removed before lighting the stove.
• The operation of the stove can cause surfaces, handles, flue system and glass to
become extremely hot. Touch these parts during operation only with protective cloth-
ing or other specialised equipment.
• Because of the build-up of heat on the glass, take care that those who are unaware
of the workings of the stove do not delay in the installation area.
• Keep children informed of safety measures to be followed when the stove is opera-
tional and at other times.
In the event of difficulties or if you are unable to understand the instruc-
tion manual contact your local Piazzetta dealer.
It is forbidden to place objects which are not heat-resistant on top of the
stove or within the prescribed minimum safety zone.
It is forbidden to open the door while the sto
ve is in operation or to oper
-
ate the stove when the glass is broken.
DIN 18894 Solid fuel stoves and fireplaces - Pellet-fired stoves - Requirements, testing and marking
UNI 10344 Heating of buildings. Calculation of energy requirements
UNI 10683 Wood-fired heat generators, Installation requirements
UNI 10847
Single flue systems for liquid and solid fuel genera
tors - Maintenance and control - Guidelines and
procedures
UNI 7129
Gas installa
tions for domestic use fired by mains gas supply
DIN 51731 class HP2 Fuels
To Next Page
Loading...