Superior MIRELLA - Page 30

30
SUPERIOR
®
English
FUEL TANK AND CASING TEMPERATURE
Sensor Description Display
Fuel-tank safety
manual reset
"
A
A
L
L
2
2
"
Located on the fuel tank, its function is to pre-
vent excessive heat surges
W
HEN ACTIV
AT
ED
If the fuel-tank temperature reaches critical lev-
els, the sensor will stop the power supply to the
fuel-loading chute, blocking the supply of fuel
to the burner and starting the shutdown
process.
• In the upper part of the display the message
"Hot tEMP", will appear and in the
lower half "
AL 2"
• The LED beside "AL C" will light up.
• After 60 seconds the alarm will sound (if acti-
vated)
O
K
SET
GRUPPO PIAZZETTA
1
2
3
4
6
AL. F
SET
FLASHING SCRIPT
LED ON
AL. C
Outer casing safety
manual rese
"
A
A
L
L
2
2
"
Positioned on the body of the stove, its job is
to check the temperature inside the cylinder
block and to ensure that the stove’s structure
and mechanisms are not damaged.
WHEN ACTIVATED
If the fuel-tank temperature reaches critical lev-
els, the sensor will stop the power supply to the
fuel-loading chute, blocking the supply of fuel
to the burner and starting the shutdown
process.
• In the upper part of the display the message
"
Hot tEMP", will appear and in the
lower half "AL 2"
•
The LED beside "
AL C" will light up.
• After 60 seconds the alarm will sound (if acti-
vated)
O
K
SET
GRUPPO PIAZZETTA
1
2
3
4
6
AL. F
SET
FLASHING SCRIPT
LED ON
AL. C
WHAT TO DO IN BOTH CASES
• Shut down the stove by holding the ON/OFF
key down for several seconds (4)
• The alarm will stop.
•
W
ait until you ar
e sure that combustion of
r
emaining pellets has stopped.
OK
SET
GRUPPO PIAZZETTA
1
2
3
4
5
6
AL. F
SET
AL. C
Before resetting the sensors, make sure the
stove has
shut down and is completely cold,
then take the following steps:
•
Unscr
ew the two caps on the bottom left of
the stove’s rear
•
One at a time, pr
ess the two small buttons. If
necessary use a screw driver with a narrow
head and apply light pressure;
•
Replace the two caps;
•
After having cleaned the burner, restart the
stove by pressing the ON/OFF key (4). (The
message
H
H
o
o
t
t
t
t
E
E
M
M
P
P
and the "AL C"
LED should no longer be showing. If this is
not the, case repeat the process.)
DT2040017-01
CAPS