5-1
Chapter 5: MegaRAID Controller Firmware Update Procedures
Chapter 5
MegaRAID Controller Firmware Update Procedures
This chapter provides instructions on how to ash MegaRAID controller rmware.
Please visit our website at www.supermicro.com for more information about rm-
ware/utilities downloads.
5-1 Flashing Firmware Using MegaCLI under DOS
1. You need the MegaCLI utility and ROM le (smc3108.rom) to ash the Mega-
RAID rmware.
2. Boot from the USB key and use the following command syntax as shown below,
or run the batch le.
megacli –adpfwash –f <lename.rom> -a0
To Next Page
Loading...
