AOC-USASLP-L8i Add-on Card User’s Manual
6-12
4. Click NEXT to continue to the next screen (see Figure 6-7).
5. Change the default volume parameters in this screen, if needed. In the top section
of the window you can specify the number of virtual disks to create. You can also
choose to use less than the full capacity of this array for the virtual disk(s).
6. Click N
EXT to continue to the next screen.
7. Check the configuration that you have just defined. If it is acceptable, click FINISH. If
you want to change something, click B
ACK to return to the previous screens.
Figure 6-7. Second Guided Configuration Screen
NOTE: You may choose to do this in order to leave capacity available for other
virtual disks that you create later.
To Next Page
Loading...
