6-13
Chapter 6: MegaRAID Window and Menus
Using Manual Configuration: RAID 0
Follow these steps to create a RAID 0 storage configuration using the Manual
Configuration mode of the Configuration Wizard.
Figure 6-8 shows the first screen that appears when you select M
ANUAL CONFIGURATION.
1. In this first screen, select two or more available drives in the left panel. Click the
right ADD arrow button to move the selected drives to the right panel.
2. Click A
CCEPT to accept these drives for the new RAID 0 array.
Figure 6-8. Manual Configuration – First Manual Configuration Screen
NOTE: MegaRAID Storage Manager software will not allow you to select the
disk drive on which the operating system is installed or any other drives that are
already part of a configuration.
NOTE: To remove a single drive from a proposed new array, select the drive
icon in the right panel and click the left R
EMOVE arrow button.
To Next Page
Loading...
