3-2
AOM-3108-H8 Add-on Module User's Guide
3-2 Before Installation
To install the add-on module properly, follow the instructions below.
1. Power down the system.
2. Unplug the power cord.
3. Use industry-standard anti-static equipment (such as gloves or wrist strap)
and follow the precautions listed on page 3-1 to avoid damage caused by
ESD
3-3 Installing the Add-on Module
The following items are needed to complete the installation:
• AOM-S3108-H8 Add-on Module
• Supercap: BTR-TFM8G-LSICVM02
• Installation Kit PN: MCP-240-00127-0N
• Spacer Kit: MCP-410-00010-0N (two spacers and four screws)
Follow the steps below to install the add-on module in your system.
1. Remove the system cover and set aside any screws for later use.
2. Install standoffs into the mounting holes.
Note: Module graphics in this manual are based on the latest revision.
Your module and motherboard may or may not look exactly the same as
the graphics shown.
Motherboard
Standoff
Standoff
Mounting
Holes
To Next Page
Loading...
