EasyManuals Logo

Supermicro H11SSL-I User Manual

Supermicro H11SSL-I
130 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
31
Chapter 2: Installation
Un-installing the Processor and Heatsink
1. Remove the heatsink attached to the top of the CPU package by reversing the
installation procedure.
2. Clean the Thermal grease left by the heatsink on the CPU package lid to limit the risk of
it contaminating the CPU package land pads or contacts in the socket housing.
3. Reverse the procedure for installing the force frame onto the socket, unscrewing the
plate in the 3-2-1 screw order and lift the force frame to the vertical position.
4. Lift the rail frame using the lift tabs near the front end of the rail frame. Note that the rail
frame is spring loaded, so be careful lifting it up into a vertical position.
5. Grip the handle of the carrier frame and pull upwards to extract it from the rail frame.
Return the carrier frame/CPU package to its original shipping container.
6. Grip the handle on the external cap and return it to the rail frame sliding it downwards
till it rests in the frame.
7. Gripping the rail frame, rotate it downwards till it rests above and locks over the socket
housing in its horizontal position.
8. Push and rotate down the force frame till it is over the external cap and rail frame into a
horizontal position.
9. While holding down the force frame, secure it back to the socket frame by securing
screw 1 in place. Note that without a CPU package in place, it is not necessary to
tighten down screws 2 and 3 at this time.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Supermicro H11SSL-I and is the answer not in the manual?

Supermicro H11SSL-I Specifications

General IconGeneral
ECCYes
Memory voltage1.2 V
Memory channelsOcta-channel
Memory slots type-
Supported memory typesDDR4-SDRAM
Maximum internal memory1024 GB
Supported memory clock speeds2666 MHz
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity2
Number of DIMM slots8
PCI Express x8 (Gen 3.x) slots3
Supported DIMM module capacities8GB, 16GB, 32GB, 64GB, 128MB
BIOS typeAMI
ACPI version5.1
BIOS memory size128 Mbit
Wi-FiNo
LAN controllerIntel I210, Realtek RTL8211E
Ethernet interface typeGigabit Ethernet
On-board graphics card modelAspeed AST2500
Bundled softwareSuper Doctor 5 Watch Dog NMI SUM IPMI 2.0, KVM w/ dedicated LAN
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)10 - 35 °C
Storage relative humidity (H-H)5 - 95 %
Operating relative humidity (H-H)8 - 90 %
Component forServer
Motherboard form factorATX
Number of SATA III connectors12
Trusted Platform Module (TPM) version1.2
Processor socketSocket SP3
Processor manufacturerAMD
Compatible processor seriesAMD EPYC
Supported storage drive interfacesSATA III
Harmonized System (HS) code84733020
Weight and Dimensions IconWeight and Dimensions
Depth244 mm
Width305 mm

Related product manuals