35
Chapter 2: Installation
3~6. Universal Serial Bus (USB) Ports
There are four USB 3.1 ports (USB 0/1, 2/3) on the I/O back panel. These support the type
A connector.
10. UID Switch and UID LED Indicator
rear UID LED (LED1) is located next to the UID switch. When you press the UID switch, both
service. See page 36 for the front panel UID LED header location on JF1.
Note: UID can also be triggered via IPMI on the serverboard. For more information on IPMI,
please refer to the IPMI User's Guide posted on our website at http://www.supermicro.com
9. VGA Port
There is one VGA port on the rear I/O panel.
2. IPMI LAN Port
One IPMI LAN port is located on the I/O back panel. This port accepts an RJ45 type cable.
1. COM Port
There is one serial communications port (COM1) on the rear I/O panel.
7~8. Gigabit LAN Ports
There are two gigabit LAN ports located on the I/O back panel (LAN1 & LAN2). These ports
accept an RJ45 type cable.
To Next Page
Loading...
