Supermicro H12SSW-NT - Front Control Panel Pin Definitions

37
Chapter 2: Installation
Front Control Panel Pin Denitions
NMI Button
The non-maskable interrupt button header is located on pins 19 and 20 of JF1. Refer to the

NMI Button
Pin Denitions (JF1)
Pin# Denition
19 Control
20 Ground
Power LED
The Power LED connection is located on pins 15 and 16 of JF1. Refer to the table below

Power LED
Pin Denitions (JF1)
Pin# Denition
15 +5V
16 Ground
HDD LED
The HDD LED connection is located on pins 13 and 14 of JF1. Attach a hard drive LED cable
here to display disk activity detected on the motherboard's built-in disk controllers. See the

HDD LED
Pin Denitions (JF1)
Pin# Denition
13 +5V
14 HDD Active
NIC1/NIC2 Link LED
The NIC (Network Interface Controller) LED connection for LAN port 1 is located on pins 11
and 12 of JF1, and the LED connection for LAN Port 2 is on Pins 9 and 10. Attach the NIC

NIC1/NIC2 LED
Pin Denitions (JF1)
Pin# Denition
9/11 Vcc
10/12 Ground