Supermicro H12SSW-NT - Page 38

38
H12SSW-iN/NT Motherboard User's Manual
UID LED
The UID LED is on pins 7 and 8 of JF1. Connect the front panel UID LED to this header to

UID LED
Pin Denitions (JF1)
Pin# Denition
7 Vcc
8 Ground
Power Fail LED
The Power Fail LED connection is located on pins 5 and 6 of JF1. Refer to the table below

Power Fail LED
Pin Denitions (JF1)
Pin# Denition
5 Vcc
6 Ground
Reset Button
The Reset Button connection is located on pins 3 and 4 of JF1. Attach the hardware reset
switch from the computer case to this header to reset the system. Refer to the table below

Reset Button
Pin Denitions (JF1)
Pin# Denition
3 Reset
4 Ground
Power Button
The Power Button connection is located on pins 1 and 2 of JF1. Momentarily contacting both
󰀨
             󰀨     

Power Button
Pin Denitions (JF1)
Pin# Denition
1 Signal
2 +3V Standby