H12SSW-iN/NT Motherboard User's Manual
52
Question: How do I update my BIOS?
Answer: It is recommended that you do not upgrade your BIOS if you are not experiencing
http://www.
supermicro.com.
To update your BIOS:
1. Check the BIOS warning message and the information on how to update your BIOS from
our website.
2. Select your motherboard model and check the current BIOS revision to make sure it is
newer than your motherboard's installed BIOS before downloading.
3.
4.
5. Boot to the motherboard's built-In UEFI Shell and type the following to start the BIOS
update process:
FLASH.nsh BIOSname#.### <ENTER>
Note: Supermicro no longer supports the BIOS update method in DOS.
6. Perform an A/C power cycle after the message indicating the BIOS update has completed.
Question: Why can't I turn o the power using the momentary power on/o switch?
Answer:
as long as the BIOS has control of the system. When the Standby or Suspend feature is
more than four seconds to shut down the system. This feature is required to implement the
ACPI features on the motherboard.
Question: When I run setup.exe to install AMD SP3 I/O drivers under windows, the
Installshield wizard shows “Unable to save le: C:\AMD\AMD_Chipset_Drivers\..... The
system cannot nd the path specied”.
Answer:
prompt you to save the drivers to a folder you designate. It will then run the driver installation
automatically.
To Next Page
Loading...
