H12SSW-iN/NT Motherboard User's Manual
66
UTF8 encoding to map Unicode characters into one or more bytes. The options are VT100,
VT100+, VT-UTF8, and ANSI.
Bits per Second
This item sets the transmission speed for a serial port used in Console Redirection. Make
sure that the same speed is used in the host computer and the client computer. A lower
transmission speed may be required for long and busy lines. The options are 9600, 19200,
57600, and 115200 (bits per second).
Flow Control
options are None,
Data Bits
Parity
Stop Bits
CPU Conguration
SMT Control
Use this setting to specify Simultaneous Multithreading. The options are Disabled and Auto.
Core Performance Boost
Auto and
Disabled.
Global C-state Control
Auto, Disabled
and Enabled.
Core Control
This sets the number of cores to be used by your system. Once this option has been used to
Options include TWO (1+1), Two (2 + 0), Three (3 + 0), Four (2 + 2), Four (4+0), Six (3 + 3)
and Auto. If unsure, leave this to Auto.
L1 Stream HW Prefetcher / L2 Stream HW Prefetcher
This setting is used to enable or disable the L1/L2 Stream Hardware Prefetcher. The options
are Auto, Disabled and Enabled.
To Next Page
Loading...
