MBI-6118G-T41X MicroBlade Module User’s Manual
1-2
1-2 Blade Module Features
Table 1-1 lists the main features of the MBI-6118G-T41X MicroBlade module. See the
proceeding section for components typically included in a blade system and other
optional components. Specific details for the MBI-6118G-T41X MicroBlade module are
found in Chapter 4: "MicroBlade Module Features" on page 4-1.
Processors
The MBI-6118G-T41X MicroBlade module supports a single FCBGA 1667 Intel Xeon
D-1581 series processors in a FCBGA 1667 socket embedded in the motherboard.
Refer to the Supermicro web site for a complete listing of supported processors (http://
www.supermicro.com/products/microblade). Please note that you will need to check the
detailed specifications of a particular blade module for a list of the CPUs it supports.
Details on installation of the processor into the MBI-6118G-T41X MicroBlade module are
found in Chapter 3: " Setup and Installation" on page 3-1.
Memory
The MBI-6118G-T41X MicroBlade module has four (4) 288-pin DIMM sockets that can
support up to 128 GB of DDR4 2133/2400 MHz speed, 32 GB size, 1.2 V voltage ECC
VLP RDIMM memory. Memory is interleaved, which requires modules to be of the same
size and speed.
Please refer to the Supermicro web site for a list of supported memory http://
www.supermicro.com/products/microblade The detailed specifications for a blade
module will contain a link to a list of recommended memory sizes and manufacturers.
Details on installation of memory modules into the MBI-6118G-T41X MicroBlade module
are found in Chapter 3: " Setup and Installation" on page 3-1.
Table 1-1. MBI-6118G-T41X MicroBlade Module Specification Features
Serverboard B1SD1-TF (proprietary form factor)
Enclosures MBE-628E-xxx and MBE-314E-xxx
Chassis Specifications
Chassis Dimensions (HxWxD): 1.2" x 4.94" x 23.2" (30.48-mm x
125.476-mm x 589.28-mm), Gross Weight: 5.67 lbs (2.57 kg)
Processors
One Intel Xeon D-1581 embedded in a FCBGA 1667 socket on the server-
board
BIOS 128 Mb SPI Flash EEPROM with AMI® BIOS
Memory Capacity
Supports up to 128 GB of DDR4 2133/2400 MHz speed and 32 GB size,
1.2 V voltage ECC VLP RDIMM memory in four (4) 288-pin DIMM sockets
Hard Drive Bays
Supports up to four 2.5" SATA3 (6 Gbps) HDD/SSD disk drives (two HDD/
SSD and two SSD)
To Next Page
Loading...
