MBI-6218G-T81X MicroBlade Module User’s Manual
3-6
Installing with a SATA-DOM Module
The MBI-6218G-T81X MicroBlade module contains a SATA-DOM socket for each node
on the serverboard. The operating system can be installed separately onto the
SATA-DOM module, which when plugged into the SATA-DOM socket of a node of the
MBI-6218G-T81X MicroBlade module, can be used as the system’s operating system
just as if it was a hard disk drive of the system.
Installing via PXE Boot
PXE (Preboot Execution Environment) is used to boot a computer over a network. To
install the OS via PXE, the following conditions must be met:
1. The PXE B
OOT option in BIOS must be enabled.
2. A PXE server has been configured (this can be another blade in the system).
3. The PXE server must be connected over a network to the blade to be booted.
4. The blade has only non-partitioned/unformatted hard drives installed and no
bootable devices attached to it.
Once these conditions are met, make sure the PXE server is running. Then turn on the
blade on which you wish to boot and/or install the OS. The BIOS in the blade will look at
all bootable devices and finding none will connect to the PXE server to begin the boot/
install.
Installing via Virtual Media (Drive Redirection)
You can install the OS via Virtual Media through either the IPMIview (Java based client
utility), IPMItool or the Web-based Management Utility. With this method, the OS is
installed from an ISO image that resides on another system/blade.
To Next Page
Loading...
