43
Chapter 3: Maintenance and Component Installation
Removing a Hot-Swap Drive Carrier from the Chassis
1. Press the release button on the drive carrier, which will extend the drive carrier handle.
2. Use the drive carrier handle to pull the drive out of the chassis.
Figure 3-6. Removing a Drive Carrier
2
1
Installing Drives
The system supports ten NVMe drives, but four hybrid ports can support SATA with an optional
cable to the motherboard, or SAS with an optional add-on card and cable. (See parts list on
the webpage, https://www.supermicro.com/products/system/1U/1029/SYS-1029U-TN10RT.
.
Four Hybrid Bays
Figure 3-5. Hybrid Bays for SAS/SATA Drives
To Next Page
Loading...
