44
SuperServer 6019P-WT8 User's Manual
Control Panel
All JF1 wires have been bundled into a single cable to simplify this connection. Make sure
the red wire plugs into pin 1 as marked on the motherboard. The other end connects to the
control panel PCB board.
M.2 Slot
The X11DDW-L has one M.2 slot located at JM2_1. M.2 was formerly known as Next
Generation Form Factor (NGFF) and serves to replace mini PCI-E. M.2 allows for a variety of
supports PCI-E 3.0 x4 (32 Gb/s) SSD cards in the 2280 and 22110 form factors.
I-SATA 3.0 and S-SATA 3.0 Ports
The X11DDW-L has eight I-SATA 3.0 ports (I-SATA0~3, I-SATA4~7) and six S-SATA ports
(S-SATA0~3, S-SATA4, S-SATA5). These SATA ports are supported by the Intel C621 chipset.
S-SATA4/S-SATA5 can be used with Supermicro SuperDOMs which are yellow SATA DOM
connectors with power pins built in, and do not require external power cables. Supermicro
SuperDOMs are backward-compatible with regular SATA HDDs or SATA DOMs that need
external power cables.
SATA 3.0 Port
Pin Denitions
Pin# Signal
1 Ground
2 SATA_TXP
3 SATA_TXN
4 Ground
5 SATA_RXN
6 SATA_RXP
7 Ground
A Holder
B Holder Mount
C Card Holder Mount
Turn 90 degrees
to lock
Locked position
with M.2 card
Locked position
Locked position
D Plastic screw
Turn 90 degrees
to lock
A+B+C
A+B+D
Press in here
B
D
A
B
C
A
Rectangle hole
on MB
Copyright © 2017 by Super Micro Computer, Inc. All rights reserved.
Hole Location on the MB 42
M.2 Card 60 A+B+C
M.2 Card 80 A+B+C
M.2 Card 110 A+B+D
To Next Page
Loading...
