Need help?Do you have a question about the Supermicro SuperServer 6026TT-HTRF and is the answer not in the manual?
General| Form Factor | 2U |
|---|---|
| CPU Socket | LGA 1366 |
| Chipset | Intel 5520 |
| Memory Type | DDR3 ECC Registered |
| Network Interface | Dual Gigabit Ethernet |
| Processor Support | Intel Xeon 5500/5600 series |
| Management | IPMI 2.0 |
Provides a general overview of the SuperServer 6026TT series, its chassis, and included components.
Details the features of the X8DTT serverboards and the SC827 chassis, including I/O, memory, and expansion.
Explains Intel Intelligent Power Node Manager and Manageability Engine for energy efficiency.
Lists contact information for Supermicro headquarters, Europe, and Asia-Pacific support.
Highlights key points about the 2U Twin2 configuration, including nodes, power, and SATA backplane.
Covers initial system unpacking, location decision, and preparation steps before rack mounting.
Details essential safety warnings for rack mounting and server handling to prevent injury or damage.
Provides step-by-step guidance for installing the chassis into a rack using provided rails.
Guides on accessing nodes, checking components, and ensuring proper serverboard installation.
Instructions on checking SATA drives, airflow, and providing power before system startup.
Explains the function of control panel LEDs, power buttons, and UID buttons on each serverboard.
Details the meanings of various LEDs on control panels and SATA drive carriers for system status.
Introduces industry-standard warnings to alert users of potential hazards and safety precautions.
Covers circuit breaker ratings, power disconnection, equipment installation, and restricted areas.
Warns about the danger of battery explosion and provides guidelines for safe replacement and disposal.
Covers ESD precautions, unpacking, and physical installation of the serverboard into the chassis.
Details connecting data, power, and control panel cables, and describes available I/O ports.
Step-by-step guide for installing LGA1366 processors and CPU heatsinks onto the serverboard.
Explains memory support and provides instructions for installing DDR3 DIMMs into the serverboard slots.
Guides on installing low-profile PCI Express x16 cards into the pre-installed riser cards.
Lists pin definitions for various motherboard connectors and explains jumper settings for configuration.
Describes onboard LEDs for LAN, BMC, and Infiniband, along with SATA port connections.
Instructions for installing system drivers and utilities from the bundled CD-ROM, including SuperDoctor III.
Provides caution and procedure for installing or replacing the serverboard's onboard battery.
Details precautions for handling static-sensitive components during chassis setup and maintenance.
Explains control panel connections and the function of system fans for cooling.
Guides on installing, removing, and handling hot-swap SATA drives and drive carriers.
Details the procedure for hot-swapping serverboard nodes from the chassis for servicing.
Covers installing air shrouds for airflow and procedures for replacing single or redundant power supply modules.
Describes the AMI BIOS Setup Utility, its navigation, and how to enter the setup screens.
Explains the main BIOS screen overview, system information, and accessing advanced configurations.
Covers configuration of CPU, clock options, chipset controls, memory frequency, and modes.
Details settings for IDE/SATA devices, DMA modes, boot device priority, and PCI/PnP configurations.
Explains BIOS security settings, password management, exit options, and BIOS recovery procedures.
Lists BIOS beep codes, their error messages, and corresponding descriptions for troubleshooting.
Lists key hardware specifications including processors, chipset, memory, expansion, and serverboard models.
Details chassis dimensions, weight, cooling, power supply, and operating environment requirements.
Outlines electromagnetic emissions, immunity, safety certifications, and perchlorate material warnings.
To Next Page