2-4
SUPERSERVER 6026TT-HT(R)F/HIBX(R)F/HIBQ(R)F USER'S MANUAL
Warning: Except for short periods of time, do NOT operate the server without
the cover in place. The chassis cover must be in place to allow proper airfl ow
and prevent overheating.
Figure 2-1: Removing the Protective Film
Check Ventilation
Openings
1
1
1
2
Reliable Ground
A reliable ground must be maintained at all times. To ensure this, the rack
itself should be grounded. Particular attention should be given to power supply
connections other than the direct connections to the branch circuit (i.e. the use of
power strips, etc.).
Removing the Protective Film
Before operating the 6026TT server for the fi rst time, it is important to remove the
protective fi lm covering the top of the chassis, in order to allow for proper ventilation
and cooling.
Removing the Protective Film
1. Peel off the protective fi lm covering the top cover and the top of the chassis
2. Check that all ventilation openings on the top cover and the top of the chassis
are clear and unobstructed.
To Next Page
Loading...
