Supermicro X11DPT-B - Page 12

12
Super X11DPT-B User's Manual
Quick Reference Table
Jumper Description Default Setting
JBT1 Clear CMOS Open (Normal)
JPME1 ME Recovery Pins 1-2 (Normal)
Connector Description
Battery (BT1) Onboard CMOS battery
COM 1 Front Panel COM Port 1
FAN 3/4 System cooling fan headers
IPMI_LAN Dedicated IPMI LAN port
JF1 Front control panel header
JF2 PCIe 3.0 x4 Slot (CPU1)
JNVI
2
C1 NVMe I
2
C header
JSD1 SATA DOM power connector
JTPM1 Trusted Platform Module (TPM)/Port 80 connector
JVRM1 VRM dongle cable header
SIOM CPU1 PCIe 3.0 x16 slot for proprietary add-on module use
SXB1 PCIe 3.0 (x4 + x4) slot supported by CPU1 and SATA connections (I-SATA0-5 & S-SATA0-5)
SXB2 PCIe 3.0 X24 slot supported by CPU2
SXB3 PCIe 3.0 x16 left hand riser slot supported by CPU1
SXB4 PCIe 3.0 x16 right hand riser slot supported by CPU2
I-SATA0-5/S-SATA0-5/I-
SATA6
I-SATA/S-SATA (3.0) 0-5 connection headers supported by Intel C621 chipset. I-SATA6: Powered
SATA connector (w/power pin built-in) with support of Supermicro SuperDOM (Disk On Module)
UID-SW UID switch
USB0/1 Back panel USB 3.0 ports
VGA Back panel VGA port
VROC (JRK1) Intel VROC RAID key header for NVMe SSD
LED Description State Status
BMC_HB_LED1 BMC Heartbeat LED Green: Blinking BMC Normal
HDD_LED1 HDD Activity LED Green: Blinking HDD Normal
UID_LED1 Rear UID LED Blue: On Unit Identied
Note 1: After you’ve enabled VMD in the BIOS on a PCIe slot of your choice, this PCIe
slot will be dedicated for VMD use only, and it will no longer support any PCIe device.
To re-activate this slot for PCIe use, please disable VMD in the BIOS.
Note 2: Intel VMD allows the user to create RAID 0 arrays without a VROC key for a
90-day trial period. After the trial period, the RAID 0 will be deleted, which could result
in data loss. In order to create an NVMe RAID, you must have a VROC key installed on
the platform. To purchase a correct VROC key from Supermicro, please refer to follow-
ing part numbers (AOC-VROCINTMOD, AOC-VROCSTNMOD, AOC-VROCPREMOD).
For detailed information on VROC, please refer to Appendix E.)