Supermicro X11DPT-B - 2.2 Installing the Motherboard

22
Super X11DPT-B User's Manual
2.2 Installing the Motherboard
All motherboards have standard mounting holes to t di󰀨erent types of chassis. Make sure
that the locations of all the mounting holes for both the motherboard and the chassis match.
Although a chassis may have both plastic and metal mounting fasteners, metal ones are
highly recommended because they ground the motherboard to the chassis. Make sure that
the metal stando󰀨s click in or are screwed in tightly.
Location of Mounting Holes
Note 1. To avoid damaging the motherboard and its components, please do not use a
force greater than 8 lb/inch on each mounting screw during motherboard installation.
Note 2. Some components are very close to the mounting holes. Please take precau-
tionary measures to avoid damaging these components when installing the mother-
board to the chassis.
Phillips
Screwdriver
(1)
Stando󰀨s (12)
Only if Needed
Phillips
Screws (12)
Tools Needed
DESIGNED IN USA
BAR CODE
BIOS LICENSE
IPMI CODE
1
+
X11DPT-B
REV:1.02
SXB1
SXB2
FAN3
FAN4
BMC_HB_LED1
UID_LED1
HDD_LED1
JPME1
SXB3_1
JSIOM1
SXB4
JSDCARD1
I-SATA6
JTAG1
JCPLD1
JRK1
BT1
JBT1
JF1
JF2
JNVI2C1
JTPM1
JSD1
CPU1 PCI-E 3.0 X4
CPU2 PCI-E 3.0 X24
I-SATA0~5
P2-DIMMF2 P2-DIMMF1
P2-DIMMD1
P2-DIMME1
P2-DIMME2 P2-DIMMD2
P2-DIMMC2
P2-DIMMC1
P2-DIMMA1
P2-DIMMA2
P2-DIMMB1 P2-DIMMB2
P1-DIMMF2 P1-DIMMF1
P1-DIMMC1 P1-DIMMC2
SIOM:CPU1 PCI-E 3.0 X16
CPU1 PCI-E 3.0 X4
S-SATA0~5
TPM/PORT80
CPU1 SLOT1 PCI-E 3.0 X16
COM1
IPMI_LAN
CPU2
PCH
USB0/1(3.0)
BIOS
FLASH
BMC
UID SW
VGA
CPU2 SLOT2PCI-E 3.0 X16
JSD1: SATA DOM POWER
CPU1
P1-DIMMD1
P1-DIMMD2
P1-DIMME1 P1-DIMME2
P1-DIMMA1 P1-DIMMA2 P1-DIMMB1 P1-DIMMB2
JVRM1
JPB1
JPG1