18
Super X11DPT-B User's Manual
1.3 Special Features
This section describes the health monitoring features of the X11DPT-B motherboard. The
motherboard has an onboard ASPEED AST 2500 Baseboard Management Controller (BMC)
that supports system health monitoring.
Recovery from AC Power Loss
The Basic I/O System (UEFI BIOS) provides a setting that determines how the system will
respond when AC power is lost and then restored to the system. You can choose for the
system to remain powered o (in which case you must press the power switch to turn it back
on), or for it to automatically return to the power-on state. See the Advanced UEFI BIOS
Setup section for this setting. The default setting is Last State.
1.4 System Health Monitoring
This section describes the health monitoring features of the X11DPT-B motherboard. The
motherboard has an onboard ASPEED AST 2500 Baseboard Management Controller (BMC)
chip that supports system health monitoring.
Onboard Voltage Monitors
The onboard voltage monitor will continuously scan crucial voltage levels. Once a voltage
becomes unstable, it will give a warning or send an error message to the IPMI WebGUI and
IPMIView. The user can adjust the voltage thresholds to dene the sensitivity of the voltage
monitor. Real time readings of these voltage levels are all displayed in IPMI interface.
Fan Status Monitor with Firmware Control
The system health monitor embedded in the BMC chip can check the RPM status of the
cooling fans. The CPU and chassis fans are controlled via lPMI 2.0.
Environmental Temperature Control
System Health sensors in the BMC monitor the temperatures and voltage settings of onboard
processors and the system in real time via the IPMI interface. Whenever the temperature
of the CPU or the system exceeds the manufacturer-dened threshold, system/CPU cooling
fans will be turned on to prevent the CPU or the system from overheating.
Note: To avoid possible system overheating, please be sure to provide adequate air-
ow to your system.
To Next Page
Loading...
