Supermicro X11SCH-F - Page 96

Super X11SCH-F/-LN4F User's Manual
96
When SEL is Full
This feature allows the user to decide what the BIOS should do when the system event
log is full. Select Erase Immediately to erase all events in the log when the system event
log is full. The options are Do Nothing and Erase Immediately.
Note: After making changes on a setting, be sure to reboot the system for the changes
to take effect.
BMCNetworkConguration
BMCNetworkConguration
UpdateIPMILANConguration
Select Yes for the BIOS to implement all IP/MAC address changes at the next system boot.
The options are No and Yes.
*If the feature above is set to Yes, the following settings will become available for
conguration:
CongureIPV4Support
This section displays conguration features for IPV4 support.
IPMI LAN Selection
This feature displays the IPMI LAN setting. The default setting is Failover.
IPMI Network Link Status
This feature displays the IPMI Network Link status. The default setting is Dedicated LAN.
CongurationAddressSource
This feature allows the user to select the source of the IP address for this computer. If
Static is selected, you will need to know the IP address of this computer and enter it to
the system manually in the eld. If DHCP is selected, the BIOS will search for a DHCP
(Dynamic Host Conguration Protocol) server attached to the network and request the next
available IP address for this computer. The options are Static and DHCP.
*If the feature above is set to Static, the following settings will become available for
conguration:
Station IP Address
This feature displays the Station IP address for this computer. This should be in decimal and
in dotted quad form (i.e., 192.168.10.253).
Subnet Mask
This feature displays the subnetwork that this computer belongs to. The value of each three-
digit number separated by dots should not exceed 255.