Supermicro X11SCL-F - Page 49

49
Chapter 2: Installation
Power LED Indicator/Speaker Header
Pins 1-3 of JD1 are used for power LED indication. By default, pins 6-7 are closed with a cap
to enable the onboard buzzer at SP1. To use an extra speaker instead, connect the speaker
connector to pins 4-7. Refer to the tables below for pin denitions.
IPMI CODE
BAR CODE
DESIGNED IN USA
MAC CODE
MEGERAC
LICENSE
+
+
ASpeed
AST2500
Intel
C242
Intel
i210
VGA
JD1
CPU SLOT4 PCI-E 3.0 X4(IN X8)
CPU SLOT6 PCI-E 3.0 X8(IN X16)
CPU SLOT5 PCI-E 3.0 X4(IN X8)
JSTBY1
JTPM1
JPWR1
JF1
I-SATA4 I-SATA5
I-SGPIO2
I-SGPIO1
JPWR2
JPI2C1
FAN4
FAN3
FAN2
FAN1
FANA
JIPMB1
JSD1
JSD2
BT1
JL1
SP1
MH11
MH10
JUIDB1 LE1
LEDBMC
LE3
LEDPWR
JBT1
I-SATA0
I-SATA3
I-SATA2
I-SATA1
JPG1
JOH1
X11SCL-F
REV:1.01
DIMMA2 DIMMA1 DIMMB2 DIMMB1
USB10(3.0)
USB8/9(3.0)
USB4/5
USB2/3
COM1
USB0/1
IPMI_LAN
USB6/7(3.0)
LAN2
CPU
NMI
JF1
LED PWR
X
LED HDD
NIC
LED UID
2
NIC
1
RST
PWR ON
FAIL
PS
M.2 PCI-E 3.0 X4
COM2
LAN1
JPME2
JWD1
1. Onboard Buzzer
2. Power LED Indicator/
Speaker Header
1
2
Onboard Buzzer
The Onboard Buzzer (SP1) is used to provide audible indicators for various beep codes. By
default, pins 6-7 of JD1 are closed with a cap, which enables the use of this buzzer. Refer
to the table below for pin denitions.
PWR LED Connector
Pin Denitions
Pin# Signal
1 VCC
2 FP_PWR_LED
3 FP_PWR_LED
Speaker/Onboard Buzzer Header
Pin Denitions
Pin# Signal
4 P5V
5 Key
6 R_SPKPIN_N
7 R_SPKPIN
Onboard Buzzer
Pin Denitions
Pin# Denition
1 Pos (+) VCC
2 Neg (-) Beep In