Supermicro X11SCL-F - Page 52

52
Super X11SCL-F User's Manual
ME Manufacturing Mode
Close pins 2-3 of jumper JPME2 to bypass SPI ash security and force the system to operate
in the manufacturing mode, which will allow the user to ash the system rmware from a
host server for system setting modications. Refer to the table below for jumper settings.
The default setting is Normal.
Manufacturing Mode
Jumper Settings
Jumper Setting Denition
Pins 1-2 Normal
Pins 2-3 Manufacturing Mode
IPMI CODE
BAR CODE
DESIGNED IN USA
MAC CODE
MEGERAC
LICENSE
+
+
ASpeed
AST2500
Intel
C242
Intel
i210
VGA
JD1
CPU SLOT4 PCI-E 3.0 X4(IN X8)
CPU SLOT6 PCI-E 3.0 X8(IN X16)
CPU SLOT5 PCI-E 3.0 X4(IN X8)
JSTBY1
JTPM1
JPWR1
JF1
I-SATA4 I-SATA5
I-SGPIO2
I-SGPIO1
JPWR2
JPI2C1
FAN4
FAN3
FAN2
FAN1
FANA
JIPMB1
JSD1
JSD2
BT1
JL1
SP1
MH11
MH10
JUIDB1 LE1
LEDBMC
LE3
LEDPWR
JBT1
I-SATA0
I-SATA3
I-SATA2
I-SATA1
JPG1
JOH1
X11SCL-F
REV:1.01
DIMMA2 DIMMA1 DIMMB2 DIMMB1
USB10(3.0)
USB8/9(3.0)
USB4/5
USB2/3
COM1
USB0/1
IPMI_LAN
USB6/7(3.0)
LAN2
CPU
NMI
JF1
LED PWR
X
LED HDD
NIC
LED UID
2
NIC
1
RST
PWR ON
FAIL
PS
M.2 PCI-E 3.0 X4
COM2
LAN1
JPME2
JWD1
1. ME Manufacturing Mode
2. Watchdog Timer
1
2
Watchdog Timer
Watchdog (JWD1) is a system monitor that can reboot the system when a software application
hangs. Close pins 1-2 to reset the system if an application hangs. Close pins 2-3 to generate
a non-maskable interrupt (NMI) signal for the application that hangs. Refer to the table below
for jumper settings. The Watchdog must also be enabled in the BIOS.
Watchdog
Jumper Settings
Jumper Setting Denition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled