Supermicro X11SCM-LN8F - PEG Port Configuration

Super X11SCM-LN8F/-F and X11SCL-LN4F User's Manual
76
Fast Boot
Use this feature to enable or disable fast path through the memory reference code (MRC).
The options are Disabled and Enabled.
REFRESH_2X_MODE
Use this feature to select the memory controller 2x refresh rate mode. The options are
Disabled, 1- Enabled for WARM or HOT, and 2- Enabled HOT only.
DMI/OPIConguration
The following DMI information will display:
• DMI
DMI Link ASPM Control
Use this feature to set the Active State Power Management (ASPM) state on the System
Agent (SA) side of the DMI Link. The options are Disabled, L0s, L1, and L0sL1
DMI Extended Sync Control
Use this feature to enable or disable the DMI extended synchronization. The options are
Enabled and Disabled.
DMI De-Emphasis Control
Use this feature to congure the De-emphasis control on DMI. The options are -6 dB
and -3.5 dB.
PEGPortConguration
CPU SLOT6 PCI-E 3.0 x16
Enable Root Port
Use this feature to enable or disable the PCI Express Graphics (PEG) device in the port
specied by the user. The options are Disabled, Enabled, and Auto.
Max Link Speed
Use this feature to congure the link speed of a PCI-E port specied by the user. The
options are Auto, Gen1, Gen2, and Gen3.
Power Limit Value
Use this feature to set the upper limit on the power supplied by the PCIE slot. Press "+"
or "-" on your keyboard to change this value. The default setting is 75.