Supermicro X11SCQ-L - Page 89

Chapter 4: BIOS
89
Serial ATA Port 0~5
This feature displays the information detected on the installed SATA drive on the particular
SATA port.
• Model number of drive and capacity
• Software Preserve Support
Serial ATA Port 0~5 Hot Plug
Set this feature to Enable for hot plug support, which will allow the user to replace a SATA
drive without shutting down the system. The options are Disabled and Enabled.
Serial ATA Port 0~5 Spin Up Device
Set this feature to enable or disable the PCH to initialize the device. The options are
Disabled and Enabled.
Serial ATA Port 0~5 SATA Device Type
Use this feature to specify if the SATA port specied by the user should be connected to a
Solid State Drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State
Drive.
PCH-FW Conguration
The following rmware information will display:
• ME Firmware Version
• ME Firmware Mode
• ME Firmware SKU
ME FW Image Re-Flash
Use this feature to update the Mangement Engine rmware. The options are Disabled and
Enabled.
Manageability Features State
Enabled this feature to allow system administrators to congure the ME BIOS extension
(MEBx) conguration settings. The options are Disabled and Enabled.
AMT BIOS Features
Disable this feature to deny access to the MEBx setup. The options are Disabled and Enabled.
*If the feature "AMT BIOS Features" above is set to Enabled, the AMT Conguration
submenu will be available for conguration: