Supermicro X11SCV-Q - Page 71

Chapter 4: BIOS
71
Turbo Mode
Select Enable for processor cores to run faster than the frequency specied by the
manufacturer. The options are Disable and Enable.
Package Power Limit MSR Lock
Select Enabled to lock the package power limit for the model specic registers. The options
are Disabled and Enabled.
Power Limit 1 Override
Select Enabled to support average power limit (PL1) override. The options are Disabled and
Enabled.
Power Limit 1
Use this feature to congure the value for Power Limit 1. The value is in milli watts and the
step size is 125mW. Use the number keys on your keyboard to enter the value. Enter 0 to
use the manufacture default setting If the value is 0, the BIOS will set PL1 as 1.25* TDP.
This feature is hidden when Power Limit 1 Override is Disabled.
Power Limit 2 Override
Select Enabled to support rapid power limit (PL2) override. The options are Disabled and
Enabled.
Power Limit 2
Use this feature to congure the value for Power Limit 2. The value is in milli watts and the
step size is 125mW. Use the number keys on your keyboard to enter the value. Enter 0 to
use the manufacture default setting If the value is 0, the BIOS will set PL2 as 1.25* TDP.
1-Core Ratio Limit Override
This increases (multiplies) 1 clock speed in the CPU core in relation to the bus speed when
one CPU core is active. Press "+" or "-" on your keyboard to change the value. Enter 32 to
use the manufacture default setting. The default value is 0 for X11SCV-Q.
2-Core Ratio Limit Override
This increases (multiplies) 2 clock speeds in the CPU core in relation to the bus speed when
two CPU cores are active. Press "+" or "-" on your keyboard to change the value. Enter 32
to use the manufacture default setting. The default value is 0 for X11SCV-Q.
3-Core Ratio Limit Override
This increases (multiplies) 3 clock speeds in the CPU core in relation to the bus speed when
three CPU cores are active. Press "+" or "-" on your keyboard to change the value. Enter 32
to use the manufacture default setting. The default value is 0 for X11SCV-Q.